|
Digitrax Chief Digital Command Control System
Digitrax Chief Starter Set
Super Empire Builder Set
Digitrax Zephyr Starter Set
1- DC100 Command Station
1- DB150 CS/Booster
1- DCS50 CS/Booster
2- DT400R Throttle (radio)
2- DT300R Throttle (radio)
2 - UT4R Throttles (radio)
2- DT400ir Throttle
2- DT100ir Throttles
1- UT1 Throttle
8- UP5 Loconet panels
5- UP3 Loconet panels
1- UR-91 Radio Receiver
1- UR-90 Infrared Receiver
1- DS-64
10- DS-54s
40- DM-1s (Power booster for Kato Turnouts)
1- BDL-162
1- RX-4
2- BD-1 Sensors
1- PS-515 Power Supply
3- PS-12 Power Supplies
2- DN-122K Decoder
5- DN-145K Decoders
1- DN-146A Decoder
8- DN-148K Decoders
3- DN-149K Decoders
6- DN-163KO Decoders
6- DN-163K0b Decoders
2- DN-163K2 Decoders
1- DN-163A0 Decoders
3- DN-163A1 Decoders
2- DN-121 Decoders
2- DZ-143 Decoders
4- MRC 330 Decoders
8 - 4 turout control boards
|
DCC:
My Digitrax Chief Starter Set is by far the best investment I have made for my model railroad. As you can see I am very partial to Digitrax and Kato. My decoder experience is limited at this time to plug and play decoders. The "Golden Spike" was added as a joke.
My DT400R and DT400IR Throttles, the infrared ones will eventually be converted to radio.
My DT300R Throttles.
My UT4R Throttles, for those times when the grandson comes to visit. He was running a train with this throttle at the age of 2 1/2.
My UP5's, UP3's, UR90 and UR91 Loconet Panels.
I have 5 UP3 and 8 UP5 Panels located around the layout. This shows the yard panel with my 2 DT100ir's.
DT400's and my UT-1.
The UR-90 located on the back wall, I have not run into any problems with reception with it located here, unless I aim the throttle down at floor.
Kato F8/9 Sante Fe A Unit with Digitrax Decoder installed,
Kato RS-2 Locomotive with Digitrax Decoder installed.
My Digitrax Zephyr Starter Set.
My DS-54's waiting to be used.
My friend builds these home made turnout control boards.
Here are a bag full of these boards waiting to be used, too.
|